![]() This will clear any DTCs that are currently active or stored in the PCM. *Example: KEY IN (OFF) – RUN – OFF – RUN – OFF – RUN – OFF – RUN – OFF – RUN Note: The RUN position is TWO clicks while the ACCESSORY position is only ONE click. Leave in the RUN position on the FIFTH cycle. Put the key in the ignition with doors closed.Ĭycle the key FIVE times from the OFF position to the RUN position without cranking the engine. 1 04-30-2020, 09:47 PM 2020 INSITE 8.6.0.104 software with password deletion function (only activated) In 2020, a new Insite 8.6.0 electronic service tool will be launched, which is very clean and virus-free It works completely differently from other versions, but uses zapit and fleet numbers, which are automatically updated. NEXIQ VXTRUCKS V8 USB Link) to clear the codes. In that case, it is best to use an OBD-II scanner (e.g. ![]() ![]() NOTE: Depending on which flash is on your PCM, there is a chance that this procedure will not work. How to clear DTCs (check engine light) on Cummins Insite without a code reader: You will be asked to turn the key off, and click a button, then key on Select “Erase all Faults” and follow the instructions. ![]() How to clear fault codes on Cummins Insite Pro:Īfter you connect to the ECM with Insite, click the “Fault Codes” tab on the left.Īfter the codes are displayed, highlight one of them & right-click on it. Cummins Insite 8.1 crack is verified to clear fault codes without any issue.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |